Easily resize your magnetic bracelet with the included tool for a perfect fit.
In the video we show you how to size your Jecanori bracelet
These instructions apply to all Jecanori link bracelets.
Full Instructions:
Step 1: Determine the Desired Fit
- Wrap the bracelet around your wrist to estimate how many links need to be removed.
Step 2: Locate the Bracelet Pin
- Find the rounded end of the pin on the side of the bracelet. This end will be slightly indented. Use the tool push pin on this side to push out the bracelet needle.
Step 3: Set Up the Sizing Tool
- Twist open the sizing tool and position your bracelet over the tool.
- Align the tool’s push pin with the bracelet pin you wish to remove. For best results, remove links from the middle section of the bracelet.
Step 4: Remove the Bracelet Pin
- Hold the bracelet steady with one hand and gently twist the knob of the sizing tool with your other hand until the pin is pushed out from the other side.
Step 5: Extract the Pin
- Twist the knob in the opposite direction to release the bracelet. Then, use your fingers to finish pulling out the pin.
Step 6: Remove Links
- Repeat the process for additional links as needed. Note: You do not need to remove each link individually; work with connected sections for efficiency.
Step 7: Reattach the Bracelet Links
- To reconnect, align the remaining bracelet links and reinsert the pin. Start by placing the smaller, rounded end of the pin into the aligned holes.
Step 8: Secure the Pin
- Push the pin against the base of the sizing tool or a hard surface until it sits flush with the bracelet. If needed, use pliers for additional pressure to fully secure the pin.
Extra Tip:
Your sizing tool includes two spare pins, in case replacements are required.
---
With these simple instructions, you’ll achieve a perfect fit for your magnetic bracelet every time!